Basic VLAN Setup Command(Ref. Given Topology)
In hyperterminal of laptop connected to Switch 1
Switch>en
Switch#config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#hostname sw1
sw1(config)#enable password 1234
sw1(config)#vlan 10
sw1(config-vlan)#name ofiicer
sw1(config-vlan)#exit
sw1(config)#vlan 20
sw1(config-vlan)#name clerical
sw1(config-vlan)#exit
sw1(config)#int fa0/1
sw1(config-if)#switchport mode access
sw1(config-if)#switchport access vlan 10
sw1(config-if)#exit
sw1(config)#int fa1/1
sw1(config-if)#switchport mode access
sw1(config-if)#switchport access vlan 20
sw1(config-if)#exit
sw1(config)#int fa2/1
sw1(config-if)#switchport mode trunk
sw1(config-if)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/1, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/1, changed state to up
switchport mode trunk
sw1(config-if)#switchport mode trunk
sw1(config-if)#switchport trunk allowed vlan all
sw1(config-if)#exit
sw1(config)#exit
sw1#
%SYS-5-CONFIG_I: Configured from console by console
wr
Building configuration...
[OK]
sw1#
sw1#
Do the Same For Switch-2 (sw2)